انواع موتور های DC
شیلد باتری 18650 لیتیومی دو سل با ورودی MicroUSB و Type-C
معرفی
شیلد باتری دو سل به عنوان یک پرتابل پاور قابل استفاده می باشد که توانایی راه اندازی انواع مصرف کننده های 3V و 5V را دارد. همچنین از این شیلد می توان برای تامین تغذیه برد های میکروکنترلری مثل Arduino و Raspberry Pi و ESP استفاده نمود.
مشخصات
ولتاژ تغذیه 5 ولت
دارای پایه های خروجی 5V/2.2A و 3V/1A
دارای خروجی USB
دارای ورودی های MicroUSB و Type-C
Specification
LED indicator(Green means full, Red means charging).
This module is a portable mobile power supply that supports 3V / 1A and 5V / 2.2A two voltage outputs!
This mobile power supply has a built-in lithium battery protection IC, which has overcurrent, overvoltage, under-voltage, etc.
5V voltage output rated current is 2.2A, maximum support 3A current (not recommended for overload, easy to damage the module, speed up the service life), the output of current depends on the quality of the 18650 battery!
4 level LED lights show power, the default boot is always in working state, you need to manually shut down (if necessary, change to non-working state automatic shutdown mode, just cut off the middle line of the “NC” bit or remove the”ROUT” resistor).
The output of current depends on the quality of the 18650 battery!
This board cannot charge mobile phones because there is no docking agreement.
Please charge and activate before using this board, otherwise it can not be used normally.
The installation of the battery must be determined positive and negative, the board has been clearly marked positive and negative! Or Installation errors will burn out the module!
The battery voltage works normally from 3.2V to 4.2V. Do not connect the batteries in series. The voltage in series will increase. If the battery capacity needs to be increased in parallel, do not connect in series.
نقد و بررسیها
هنوز بررسیای ثبت نشده است.